Grasslands Range report

[BigAl52]

Today I went to the grasslands again. It was a nice day out there and not much wind. I took out an AR to check where it was shooting. Turns out it was dead on and I only shot 10 rounds thru it and put it away. Next up Henry SS in 357. I like this gun light weight easy to shoot and I have a red dot on it. Ive thought about a scope but the dot is doing the trick for me now. The following targets are with 4 different loads and only one load is a different powder. That being HS-6. I have alot of it. It shoots pretty good although there is some inconsistency with it.

IMG_2105.JPG (153.06 KiB) Viewed 1228 times

This target is the 180gr pugnose at 50 yards off the bench. Powder 2400 11.5 grains. These bullets hammer anything they hit.

IMG_2106.JPG (141.39 KiB) Viewed 1228 times

This target is 158gr Roze Dist. with 13.5 grain of 2400. Very accurate load I think. If I had a scope I bet they would have been tighter

IMG_2093.JPG (161.83 KiB) Viewed 1228 times

This target is 15gr 2400 and a Hornady XTP 158 gr bullet. Ive used this load in other guns with great success. It works good here to.

IMG_2107.JPG (146.54 KiB) Viewed 1228 times

Last load is 9.2 grains of HS-6 and the Roze bullet 158gr HP. The roze bullets shoot good. Wish they werent out of them. Also 2400 is a performer. Its always been my go to powder for the upper loads in 357. I have quite a few loaded up with the HS-6. I blew one of those shots in that group on the final target but that happens to me more than not. I need to hand it over to NCG or Ranchroper Most of these hits would make the steel gong ring that I have and thats all I really care about. YMMV

[Rifletom]

Dang Al, good day at the range I'd say! That 180/2400 load is sooo reliable in .357. You had a damn good day bud.

[zara_puppy]

Excellent! You are a mind reader!!! I just ordered a SS .357. I use 2400 for loading .44’s and .357’s for revolvers. I was going to post the question “has anyone happened to come upon a .357 load for a Single Shot Henry using 2400?”

Boom!! Here you are. I use 13.5 grains and a 158 Grain XTP for the GP100. Looks like I should be able to use the same load for both.

No kidding - I came here looking for exactly this. You are the man!

[North Country Gal]

Those are very good, consistent groups using a red dot, Al. I'd be happy with them. Really like that 158 Roze group. Be worth adding a scope, sometime.

[Kissmybrass]

Nice shooting Al! I have had excellent results with the HS-6 and 158 grain Hornady XTPs. Have a bunch of .38 ready to go (once I get a crimp on em) with 110 grain XTPs and HS-6 as well.

[fortyshooter]

I like the pugs and the 158 XTP targets. With a touch of elevation adjust the 158 XTP look excellent! Great shooting Al!

[brm4450]

44F8417F-52E1-43F1-98AE-FC9922EAB2CC.gif (275.12 KiB) Viewed 1201 times

[Hatchdog]

Nice shooting Al and thanks for showing the results of the different bullets. All are winners indeed.

[Shakey Jake]

Good shootin'!
Jake

[Sir Henry]

The 158 Roze was dead on.