Henry 357

bluestringer · Post by **bluestringer** » Mon Jul 13, 2020 5:07 pm

I have a Henry steel in 357. Just wondering if anyone shoots 38 Special in these. Do they cycle ok?

Post by **BigAl52** » Mon Jul 13, 2020 5:51 pm

I have shot 38 special in mine but don’t do it to much. Mine cycles them just fine

Post by **Steve51** » Mon Jul 13, 2020 6:10 pm

.38 specials function fine in mine but I rarely shoot them as my sights are set for hot .357 magnums at 50 yds.

Post by **Rifletom** » Mon Jul 13, 2020 6:24 pm

Same as Al and Steve. .38's cycle fine thru my Henry. Like shooting a .22!

Post by **markiver54** » Mon Jul 13, 2020 6:46 pm

Have not even run any 38's thru mine. I have heard though, that on rare occasions you can get a jam while cycling
I believe the shorter length is the problem.
The rifle was designed mostly with the 357 in mind.

Post by **glb** » Mon Jul 13, 2020 10:52 pm

had some so I tried them jammed up so bad I had to have a gun smith get it out. neve tried again

Chugbug · Post by **Chugbug** » Mon Jul 13, 2020 11:16 pm

I just bought a 357 steel and could only find 38s (Blazer brass 125 JHP). I had 2 hang ups in the 1st 10 rounds. I realized I was the problem......the next 90 rounds cycled perfectly.

Post by **The Wiz** » Tue Jul 14, 2020 12:01 pm

Got to be firm with the action. .38's work find in both of my .357's

Henry Rifle Forums

Henry 357

Henry 357

Re: Henry 357

Re: Henry 357

Re: Henry 357

Re: Henry 357

Re: Henry 357

Re: Henry 357