Page 1 of 1

Screw question

Posted: Sat Dec 02, 2023 10:45 pm
by 5shot
Wondering if anyone can tell me what function this screw serves? The reason I ask is because on my last outing with this .44 X Model I had a few unexplained flyers and when checking the screws back home this one was loose by over a full turn. Could that have been a factor in the flyers?
I know the obvious answer is tighten it up and shoot again but....I've got a knee replacement coming up next week and don't know if a range trip before then is going to happen.
So...anyone??
Screw.jpg

Re: Screw question

Posted: Sun Dec 03, 2023 7:02 am
by Ozarkwoodswalker
Hope the knee replacement goes well!

Re: Screw question

Posted: Sun Dec 03, 2023 2:17 pm
by Mags
5shot wrote:
Sat Dec 02, 2023 10:45 pm
Wondering if anyone can tell me what function this screw serves? The reason I ask is because on my last outing with this .44 X Model I had a few unexplained flyers and when checking the screws back home this one was loose by over a full turn. Could that have been a factor in the flyers?
I know the obvious answer is tighten it up and shoot again but....I've got a knee replacement coming up next week and don't know if a range trip before then is going to happen.
So...anyone??

Screw.jpg
Outer Mag Tube Set Screw.

Re: Screw question

Posted: Sun Dec 03, 2023 2:29 pm
by 5shot
Screw.jpg
[/quote]
Outer Mag Tube Set Screw.
[/quote]

Does that mean I have to come up with some other excuse for lousy shooting? :oops: I figured that the screw being directly under the magazine that's what it was but wondered if it also in some way supported the action? Kind of like the front screw on a bolt gun. :?

Re: Screw question

Posted: Sun Dec 03, 2023 2:31 pm
by 5shot
Ozarkwoodswalker wrote:
Sun Dec 03, 2023 7:02 am
Hope the knee replacement goes well!
Thank you. I was hoping to finish out this tour of duty with original issue running gear but it was not to be.

Re: Screw question

Posted: Sun Dec 03, 2023 2:53 pm
by Ozarkwoodswalker
Im running on several after market parts... an artificial hip,have a stent by my heart, a piece of wire in my shoulder new multifocal lens implants in my eyes, and of course some crown and bridge work.... all better than wore out parts... im sure you will be happy with your knee once you get healed up....

Re: Screw question

Posted: Mon Dec 04, 2023 1:12 am
by Mags
5shot wrote:
Sun Dec 03, 2023 2:29 pm
Screw.jpg
Outer Mag Tube Set Screw.
Does that mean I have to come up with some other excuse for lousy shooting? :oops: ...
Maybe the loose outer mag tube rattling around at the receiver end jerks the other end of the mag tube around at the muzzle during recoil :?: :mrgreen:

Re: Screw question

Posted: Mon Dec 04, 2023 2:25 am
by Sir Henry
Ozarkwoodswalker wrote:
Sun Dec 03, 2023 2:53 pm
Im running on several after market parts... an artificial hip,have a stent by my heart, a piece of wire in my shoulder new multifocal lens implants in my eyes, and of course some crown and bridge work.... all better than wore out parts... im sure you will be happy with your knee once you get healed up....
I’m running on all OEM although I’ve been told I have a screw loose.

Re: Screw question

Posted: Mon Dec 04, 2023 2:00 pm
by Mr. Neutron
I think we need to come up with a list of poor shooting excuses. We could number each one, and simply write down the appropriate excuse # when we post. How easy could that make it, and it would enhance all our lives? :mrgreen: :roll: :lol: :oops: I would've used them all by now......

5shot, I too hope your replacement goes well. I'm a recipient of 2 of 'em myself. Doin' really well with mine, but I really pushed my rehab/PT hard after the surgeries. My only regrets are what the scars have done to my knee modeling career...... :lol:

Try to exceed every thing they ask you do for yor recovery, especially the flexibility & strengthening exercises. Don't be afraid to push yourself hard; it'll benefit you tremendously down the road. And a good recumbant exercise bike can become your new best friend after a knee replacement! ;)

The folks I know that had THE MOST PROBLEMS after a knee replacement were those that wouldn't work through the pain (Not gonna lie; there will be some pain, but it's only for a short time frame) and didn't push the rehab either at all, or gave only a half-hearted effort. With knee replacements, the surgery is 50% what your doctor does, and the other 50% is what YOU do......

Re: Screw question

Posted: Mon Dec 04, 2023 5:33 pm
by 5shot
Thank you Mr. Neutron! I appreciate the sound advice from someone who's been there, done that and got the t-shirt! Everyone I've talked to has pretty much said the same thing you did and the failure stories have involved people that thought they could "sandbag" on the rehab efforts. I had to stick pretty close to camp this deer season and that alone should be enough incentive to motivate me!

My favorite excuses are "That dang target won't sit still" or "The crosshairs were right on target the last time I looked". :lol:

Re: Screw question

Posted: Mon Dec 04, 2023 7:37 pm
by Mr. Neutron
5shot wrote:
Mon Dec 04, 2023 5:33 pm
My favorite excuses are "That dang target won't sit still" or "The crosshairs were right on target the last time I looked". :lol:
There's #1 & #2 right there...... :lol: :lol: Can I use 'em also???

#3 might be something like "Are we supposed to keep both eyes open when we shoot??".
I had to stick pretty close to camp this deer season and that alone should be enough incentive to motivate me!
Keep that thought in the back of your mind as you do the stretches and exercises you'll be given, 5shot!!! It'll serve you well! ;)

My wife bought me a well-made but inexpensive Weslo brand recumbant bike. Some days, after my 2.5-3 mile walks, my new fake knees might be a tad sore after the downhill parts of my walkin'. But the knees almost always feel better after 20-30 minutes on that exercycle. There will be pools of sweat on the basement floor afterwards, but the knees feel great. This time of year in /western Oregon, it's a toss up if I get wetter from sweatin', or walkin' oudoors.... :roll: I have a daylight basement, so I can look out windows for a distraction, and listen to music, etc.. That helps a bunch. Ya really kinda have to commit to keepin' up a regimen of whatever you like to keep weight off and make it easier on the knew metal knees. If I could only learn to NOT eat like an idiot...... :oops: :mrgreen:

Re: Screw question

Posted: Mon Dec 04, 2023 7:57 pm
by Mr. Neutron
#4: "I don't have a trigger finger, I have a trigger sausage"......

Re: Screw question

Posted: Mon Dec 04, 2023 9:00 pm
by 5shot
Maybe the all time best one I ever heard was......Every year before deer season we open up our range to the public for sight in. We charge $5 per gun and it makes a nice fundraiser for the club. I had a guy a couple years ago that was flinching so bad with his .300 megablaster that it was hard to get him dialed in for a zero. He explained...."I ain't much good on paper but just put a deer in front of me and lookout." :shock: OHHHHHKAY :lol: :lol:

Re: Screw question

Posted: Mon Dec 04, 2023 9:15 pm
by Travlin
I hope that all works out for you. Is that a split in the forearm?

Re: Screw question

Posted: Mon Dec 04, 2023 9:27 pm
by 5shot
Travlin wrote:
Mon Dec 04, 2023 9:15 pm
I hope that all works out for you. Is that a split in the forearm?
It may look that way in the pic but it's a seam from when the stock was made. Definitely not a split.

Re: Screw question

Posted: Tue Dec 05, 2023 9:11 pm
by Travlin
Very good news I am glad that all is well with the stock.

Re: Screw question

Posted: Mon Dec 25, 2023 4:21 pm
by pennsylvaniapete
#5 I inhaled when I should have exhaled…