Henry Rifle Forums

One time, as I field stripped the gun, as soon as I separated the stock and FCG from the receiver, I heard something falling on the carpet protector. I looked at the pieces and saw nothing missing. I wrote it up for a piece of brass or some random debris. I put it back and it worked find. But when I took it apart again, there was no resistance on the rearmost pin at all.

You can guess what it was: both clips vacated their positions. Miraculously, I was able to recover both of them (by scanning the area with a bright flashlight).

As you can see, one of the little D-clips is a little opened up. It jumped out of its place first. I didn't notice it, because I was looking at the mechanism from
the opposite side, where the remaining clip was.

For now I put them both back in place.

We've all been there when parts somehow relocate themselves during disassembly. I find the bright light helps too, as does a strong magnet that you can sweep over the area with. Not everything is magnetic, but most is.

I hope you squooze shut that open one a bit before reinstalling it.

I did close it, although it was a little challenging. If I just compress it with pliers, it springs right back. I used jeweler's bending pliers with a channel.