Page 1 of 2
Remington Standard V Rimfire
Posted: Mon Jul 27, 2026 11:37 pm
by Sir Henry
I’m thinking of stocking up on these. I can get 550 rounds for $35. Thats just over six cents a round and a lot less than the sixteen cents I pay for CCI SV.
Re: Remington Standard V Rimfire
Posted: Tue Jul 28, 2026 8:21 am
by rickhem
I've tried these a couple times, and the number of misfires was more than what I thought was acceptable. At least one in every 50 rounds, which worked out to two alibis in a rimfire 900 match. Granted, that was a decade or more ago. They shot great when they worked, grouped quite well, but the ones that didn't go bang were my issue. CCI has gone through their struggles too, especially ammo from about 5 years ago, but the newer stuff is way better, giving me only about one dud per brick.
If you are just plinking, and an occasional dud isn't costing you anything but a few seconds to get that one out and put another one in, then they group pretty good.
Re: Remington Standard V Rimfire
Posted: Tue Jul 28, 2026 12:22 pm
by Mags
Those are 6 cents each here as well. But Standard Velocity CCI is 9 cents a round. CCI Quiet, Suppressor and Clean are in the 16 cent to 17 cent range. MiniMag are 11 cents.
Re: Remington Standard V Rimfire
Posted: Tue Jul 28, 2026 12:36 pm
by Sir Henry
I just need cheap plinking ammo. They were out even though they said they have them. The guy said that might mean they are on the truck for delivery. I might buy three loose bricks and test them. I’ve had bad luck with Thunderbolts and good luck with their hyper rounds.
rickhem wrote: ↑Tue Jul 28, 2026 8:21 am
I've tried these a couple times, and the number of misfires was more than what I thought was acceptable. At least one in every 50 rounds, which worked out to two alibis in a rimfire 900 match. Granted, that was a decade or more ago. They shot great when they worked, grouped quite well, but the ones that didn't go bang were my issue. CCI has gone through their struggles too, especially ammo from about 5 years ago, but the newer stuff is way better, giving me only about one dud per brick.
If you are just plinking, and an occasional dud isn't costing you anything but a few seconds to get that one out and put another one in, then they group pretty good.
Mags wrote: ↑Tue Jul 28, 2026 12:22 pm
Those are 6 cents each here as well. But Standard Velocity CCI is 9 cents a round. CCI Quiet, Suppressor and Clean are in the 16 cent to 17 cent range. MiniMag are 11 cents.
Re: Remington Standard V Rimfire
Posted: Tue Jul 28, 2026 4:56 pm
by Mags
Sir Henry wrote: ↑Tue Jul 28, 2026 12:36 pm
I just need cheap plinking ammo. ...
I hope you find them accurate enough for that. I'd like to know if they are. I'd like to have a good alternative. A good while back I bought a brick of Federal Champion AutoMatch. They were crap shot from a rifle. I still have most of the brick. I sometimes shoot a few from a revolver at close range. Mostly I shoot CCI Shorts, Quiets and Standard in my revolvers and MiniMag in my rifle.
Re: Remington Standard V Rimfire
Posted: Tue Jul 28, 2026 7:44 pm
by Sir Henry
Mags wrote: ↑Tue Jul 28, 2026 4:56 pm
Sir Henry wrote: ↑Tue Jul 28, 2026 12:36 pm
I just need cheap plinking ammo. ...
I hope you find them accurate enough for that. I'd like to know if they are. I'd like to have a good alternative. A good while back I bought a brick of Federal Champion AutoMatch. They were crap shot from a rifle. I still have most of the brick. I sometimes shoot a few from a revolver at close range. Mostly I shoot CCI Shorts, Quiets and Standard in my revolvers and MiniMag in my rifle.
I’ve found the Federal AutoMatch to be poor ammo also. Yet their XM193 is the best. Most manufacturers make a superior product and also a dud. Think Edsel and Mustang.
Re: Remington Standard V Rimfire
Posted: Fri Aug 07, 2026 9:43 am
by Sir Henry
I ended up ordering a case of the Remington Standard V. I hope they work. I like their HV shorts but don’t like much else.
Re: Remington Standard V Rimfire
Posted: Sat Aug 08, 2026 8:06 am
by Vaquero
Mags wrote: ↑Tue Jul 28, 2026 4:56 pm
Sir Henry wrote: ↑Tue Jul 28, 2026 12:36 pm
I just need cheap plinking ammo. ...
I hope you find them accurate enough for that. I'd like to know if they are. I'd like to have a good alternative. A good while back I bought a brick of Federal Champion AutoMatch. They were crap shot from a rifle. I still have most of the brick. I sometimes shoot a few from a revolver at close range. Mostly I shoot CCI Shorts, Quiets and Standard in my revolvers and MiniMag in my rifle.
I've never seen Federal Champion Auto-match.
Now the 325 bulk Federal Auto-match, I've bought a bunch of and have quite a bit on hand. They have shot fine in several different rifles, even in the cheap Henry. In fact while at WW yesterday I bought another, $19.99 + tax.
RP
Re: Remington Standard V Rimfire
Posted: Sat Aug 08, 2026 8:17 am
by HenryFan
Not terribly long ago, probably within the last three months, I bought a box of Remington Viper truncated cone HV ammo for testing in a Ruger SP 101. I haven't shot much of it but I was pleased that there were no duds in the small amount I shot.
I think it is the first Remington rimfire ammo I have bought in two decades because the last Remington rimfire ammo I bought, bulk pack golden bullets, was of such poor quality. Very poor quality.
I hope Remington is back on the road to producing good rimfire ammunition once again. More suppliers and more choices are always better.
Re: Remington Standard V Rimfire
Posted: Sat Aug 08, 2026 8:52 am
by Sir Henry
I’ve had poor luck with Golden Bullets and and Thunderbolts. Vipers and Yellow Jackets are good.
Re: Remington Standard V Rimfire
Posted: Sat Aug 08, 2026 12:19 pm
by Mags
Vaquero wrote: ↑Sat Aug 08, 2026 8:06 am
Mags wrote: ↑Tue Jul 28, 2026 4:56 pm
Sir Henry wrote: ↑Tue Jul 28, 2026 12:36 pm
I just need cheap plinking ammo. ...
I hope you find them accurate enough for that. I'd like to know if they are. I'd like to have a good alternative. A good while back I bought a brick of Federal Champion AutoMatch. They were crap shot from a rifle. I still have most of the brick. I sometimes shoot a few from a revolver at close range. Mostly I shoot CCI Shorts, Quiets and Standard in my revolvers and MiniMag in my rifle.
I've never seen Federal Champion Auto-match.
Now the 325 bulk Federal Auto-match, I've bought a bunch of and have quite a bit on hand. They have shot fine in several different rifles, even in the cheap Henry. In fact while at WW yesterday I bought another, $19.99 + tax.
RP
It was 325 bulk pack I bought a couple of decades ago. That was my experience with it back then. I haven't shot much of it since then.
Re: Remington Standard V Rimfire
Posted: Wed Aug 12, 2026 5:23 pm
by Sir Henry
I received a 6,600 round cast of the Standard V. The 25 I shot in the 10/22 and 10 I shot in the 22/45 all went bang and all hit the gong.
- IMG_0212.jpeg (2.55 MiB) Viewed 1327 times
Re: FIRST flaw Standard V Rimfire
Posted: Sat Aug 22, 2026 12:59 pm
by Sir Henry
After approximately 800 rounds I had my first flaw. I was shooting a 10/22 with a ten round rotary magazine. The magazine did not advance the next round. I think its more the magazine’s fault than the ammo so I’m not blaming the ammo.
Re: Remington Standard V Rimfire
Posted: Sat Aug 22, 2026 5:22 pm
by Sir Henry
I’ve been shooting the Standard V all day and have brought more firearms into play. I’m at about 1,000 rounds without a failure.
- IMG_0273.jpeg (3.5 MiB) Viewed 1058 times
- IMG_0274.jpeg (4.1 MiB) Viewed 1058 times
Not pictured is a CZ 452 2E American that made an 1/8” group at 35 yards.
Re: Remington Standard V Rimfire
Posted: Sat Aug 22, 2026 5:42 pm
by HenryFan
Sir Henry -
Is the bottom rifle in the top photo a 10/22 International? If so, I like it. A lot.
I have always been weak when it comes to full-stock rifles. I have two, a Ruger 10/22 International with blue steel finish/walnut stock and a Ruger 77/22 in .22 WMR, also with blue steel finish/walnut stock.
It would take someone with deep pockets to charm me out of either rifle.
Re: Remington Standard V Rimfire
Posted: Sat Aug 22, 2026 5:53 pm
by Sir Henry
More shooting and more firearms. This time wheelguns. The Uberti has a tight chamber and if the bullets dont seat all the way the cylinder won’t turn. All three shot the ammo without issue.
- IMG_0277.jpeg (2.34 MiB) Viewed 1036 times
Re: Remington Standard V Rimfire
Posted: Sat Aug 22, 2026 5:57 pm
by Sir Henry
HenryFan wrote: ↑Sat Aug 22, 2026 5:42 pm
Sir Henry -
Is the bottom rifle in the top photo a 10/22 International? If so, I like it. A lot.
I have always been weak when it comes to full-stock rifles. I have two, a Ruger 10/22 International with blue steel finish/walnut stock and a Ruger 77/22 in .22 WMR, also with blue steel finish/walnut stock.
It would take someone with deep pockets to charm me out of either rifle.
Yes it is. It has a receiver mounted peep.
- IMG_0281.jpeg (2.08 MiB) Viewed 1027 times
Re: Remington Standard V Rimfire
Posted: Sat Aug 22, 2026 6:08 pm
by HenryFan
That's a prize!
Re: Remington Standard V Rimfire
Posted: Sat Aug 22, 2026 6:57 pm
by Sir Henry
HenryFan wrote: ↑Sat Aug 22, 2026 6:08 pm
That's a prize!
It’s a fun shooter.
Re: Remington Standard V Rimfire
Posted: Sun Aug 23, 2026 10:48 am
by Hatchdog
HenryFan wrote: ↑Sat Aug 22, 2026 6:08 pm
That's a prize!
Agreed, cool sight.