solid hard cast

Post by **dngnmn** » Mon Dec 28, 2020 1:50 pm

I just purchased a Henry side gate 45-70. the only ammo I was able to find, was Doubletap 405 gr Hard cast. Is this ammo o.k. to shoot in the brass rifles?

Post by **MuddyWaters62** » Mon Dec 28, 2020 3:22 pm

Yes, the Underwood ammo is good stuff. It is punchy on both ends. The cowboy stuff is a lot tamer. Think about reloading seriously unless of course your sitting on Ft. Knox. You can run the full gambit of very well behaved Trapdoor loads to near .458 magnum. I hope you will like your new Henry.

Muddy Waters 67

Post by **BigAl52** » Mon Dec 28, 2020 8:26 pm

I can feel that one before you pull the trigger. It will say hello to you for sure.

Post by **dngnmn** » Wed Dec 30, 2020 1:20 am

I called Henry. Should be no problem with 405 gr.

Post by **JEBar** » Wed Dec 30, 2020 8:39 am

I agree with MuddyWaters .... when you pull the trigger, be prepared for a punch

Post by **Oldbrass** » Wed Dec 30, 2020 12:57 pm

It'll get your attention for sure. The Henry action is over built like a tank so any factory load is fine. If reloading just follow established data

Henry Rifle Forums

solid hard cast

solid hard cast

Re: solid hard cast

Re: solid hard cast

Re: solid hard cast

Re: solid hard cast

Re: solid hard cast