Page 1 of 1
Anti-walk bolts?
Posted: Wed Jul 18, 2018 11:03 am
by cowboyzombie69
So I searched around but can't seem to find an answer. Is there a company that makes anti-walk hardware (screws/bolts) for these lever guns? We put anti-walk pins on AR's but I can't find anything for my H010.
My lever pivot screw and the screw for the butt stock keep working loose even after cleaning, blue loctite and tightening.
What is everyone else's solution to this issue if they are having this problem?
Thanks
Re: Anti-walk bolts?
Posted: Wed Jul 18, 2018 11:52 am
by Mags
blue loctite would have been my suggestion. since that didn't work, see if Henry CS has suggestions. Jeff Post:
jeff@henryusa.com
Re: Anti-walk bolts?
Posted: Thu Jul 19, 2018 12:42 am
by cowboyzombie69
Mags wrote:blue loctite would have been my suggestion. since that didn't work, see if Henry CS has suggestions. Jeff Post:
jeff@henryusa.com
Awesome thanks. I just don't want to carry around a screw driver or have my lever fall off out in the field.
Re: Anti-walk bolts?
Posted: Thu Jul 19, 2018 1:10 am
by Mags
Hopefully that never happens. A lost screw would be more concerning. A lever is big enough to find not so much the screw.
Should probably still carry a screw driver or at least a fine pick of some sort or multi-tool in case there is need to dig out a jammed casing.
Re: Anti-walk bolts?
Posted: Thu Jul 19, 2018 11:19 am
by cowboyzombie69
Mags wrote:Hopefully that never happens. A lost screw would be more concerning. A lever is big enough to find not so much the screw.
Should probably still carry a screw driver or at least a fine pick of some sort or multi-tool in case there is need to dig out a jammed casing.
Yeah that's my concern. I attached a SOG multi tool to my "go-pack" some time ago and it's come in handy quite a few times. I just don't like having to worry about my firearms when I'm in the middle of nowhere.
Re: Anti-walk bolts?
Posted: Sat Jul 21, 2018 7:21 am
by Leonardo
One must clean the oil from the threads for threadlocker to work properly. Both the receiver and the bolt/screw must be clean. I use a wire brush and low heat to remove old threadlocking compound and naptha to remove oils.
Re: Anti-walk bolts?
Posted: Sat Jul 21, 2018 12:49 pm
by Mags
Leonardo wrote:One must clean the oil from the threads for threadlocker to work properly. Both the receiver and the bolt/screw must be clean. I use a wire brush and low heat to remove old threadlocking compound and naptha to remove oils.
Good point.