Page 1 of 1
Steel plinking with the Henry BB 45 Colt
Posted: Fri Jun 30, 2017 5:52 am
by retAFShooter
I had the Henry BB 45 Colt, Cowboy Edition II, off the wall for it's semiannual shoot the other day:
https://www.youtube.com/watch?v=DOOpHQoKcB0
Re: Steel plinking with the Henry BB 45 Colt
Posted: Fri Jun 30, 2017 8:17 am
by JEBar
nicely done .... any comments on the ammo used ? .... very nice display case
Re: Steel plinking with the Henry BB 45 Colt
Posted: Thu Jul 13, 2017 6:57 am
by retAFShooter
JEBar wrote:nicely done .... any comments on the ammo used ? .... very nice display case
Yes, The Henry didn't handle the Flat Points (FP) very well. A little bit of sticking during the reload action. Seems that it might like RN better. I'll look into that.
Re: Steel plinking with the Henry BB 45 Colt
Posted: Tue Jul 18, 2017 12:25 pm
by ssonb
I looked at the ammo website on the rounds you were using and it seems that the brass cases need a taper crimp, I use a similar bullet in my BBS 44 from Ranier, The square lip on the case may be the culprit. I load a Kieth 250 gr SWC and have to seat the bullet all the way up to the shoulder and then crimp, If I don't it causes a hang up and you have to two step with the lever . Those profile bullets should feed perfectly.