Page 1 of 2
Problem with new Henry
Posted: Mon Feb 24, 2025 7:40 pm
by Mcarlcochran
All,
I have just bought a new Henry 45-70 brass side gate 22" barrel. I am experiencing feeding issues with the Hornady LeverEvolution 325gr ammo. On the first round the cartridge will get stuck on the carrier with only about .25in if the cartridge coming out of the magazine. The action will be stuck open and I have to take a cleaning rod to push the round back into the magazine with great difficulty. This has happened 3 times in 15 rounds. Is it just this ammo or do you think there is a magazine issue? Thanks
Re: Problem with new Henry
Posted: Mon Feb 24, 2025 9:58 pm
by Mags
Does this always happen with the first round levered from a full magazine?
Officially the magazine holds 4 rounds, if you squeeze 5 in, then you might get too much compression on the mag tube spring resulting in too much pressure on the carrier/lifter group in the receiver.
Also, when operating the lever, remember to do so with firm rapid authority.
Re: Problem with new Henry
Posted: Mon Feb 24, 2025 10:44 pm
by BigAl52
Try also cleaning the tube
Re: Problem with new Henry
Posted: Tue Feb 25, 2025 8:56 am
by Mcarlcochran
I was only loading 3 rounds at a time for sighting the rifle in. Happened 3 times out of 15 rounds. About every other time u loaded it
Re: Problem with new Henry
Posted: Tue Feb 25, 2025 9:50 am
by BrokenolMarine
Call Henry Customer Service and talk with them. They will get you straight one way or another. You might need to send the rifle back, but normally the turnaround time is quick.
Re: Problem with new Henry
Posted: Tue Feb 25, 2025 11:55 am
by Mags
Mcarlcochran wrote: ↑Tue Feb 25, 2025 8:56 am
I was only loading 3 rounds at a time for sighting the rifle in. Happened 3 times out of 15 rounds. About every other time u loaded it
Ya, call Henry on that.
Re: Problem with new Henry
Posted: Tue Feb 25, 2025 7:53 pm
by Mcarlcochran
Thanks, I have called Henry and got a shipping label. I'm going to try different ammo first before sending it out.
Re: Problem with new Henry
Posted: Sat Mar 01, 2025 6:37 pm
by leverjc
20220112_155032.jpg
If you haven't sent your rifle back to Henry, you might think of taking it down and seeing if it has any built of grease or foreign matter. I had a BBS that was full of a substance that looked like fiberglass covered with goo. I cleaned the gun then relubed it. It worked good after that.
Re: Problem with new Henry
Posted: Tue Nov 04, 2025 9:29 pm
by oldinguy
I hope they get it straightened out for you. That is the only round I shoot and have never had a feeding issue.
Re: Problem with new Henry
Posted: Wed Nov 05, 2025 6:50 am
by CT_Shooter
Mcarlcochran wrote: ↑Tue Feb 25, 2025 7:53 pm
Thanks, I have called Henry and got a shipping label. I'm going to try different ammo first before sending it out.
