Henry Rifle Forums

I'm looking for the same size as the inner mag tube plug. I thought I saw a post on here where one was either turned down or purchased. As it sits now, the muzzle device is too thick, by a gnats whisker, for the tube to pass. If I replace the knurled end cap with one the same size as the brass tube it will pass.

Does anyone know of what I am talking about?

I get what you sayin. You need to have one made that is the size of the first step and not the larger knurled diameter.

You could drive the pin out and remove it to turn it down or make up a new one the smaller size. Note the retaining pin comes out one way.

Pretty much that, but i don't have access to a lathe. I thought there was someone selling them a while back.

Where are you located?

central va, goochland area

Sent you a PM

Henry will fix it.