mag tube to big boy

torchred99 · Post by **torchred99** » Mon Dec 26, 2016 9:14 pm

Santa's present to me was a big boy 44 .............tried to remove mag tube to load some shells but can barely rotate the tube.......any ideas?

thanks

Post by **Travlin** » Mon Dec 26, 2016 9:24 pm

E-mail the Boss @ H.R.A.

Post by **JEBar** » Mon Dec 26, 2016 9:58 pm

heck of a Santa present ..

.. with the tube, I'd suggest you remove it and clean/lightly lube both the tube and its holder .... if that doesn't solve the problem, call Henry .... they will make it right in a hurry

1911ly · Post by **1911ly** » Tue Dec 27, 2016 12:39 pm

Did you firmly push the tube in before you turned it? If did where you able to push it in? Look at the two captive locking pins on the end and see what position they are in.

Regardless of the issue Henry will take care of you,

Post by **RanchRoper** » Thu Dec 29, 2016 11:39 am

If it continues contact HRA. They'll help you for sure.

Steve · Post by **Steve** » Thu Dec 29, 2016 12:18 pm

In my BB 45 the tube was hard to turn. I just removed the O-ring at the end, depressed the follower with a piece of scrap wood to protect the follower, file the tubing back to allow it to turn in the room available (removed only a few thousandths on mine). Replace O-ring. (Less work than shipping the gun back.)

Henry Rifle Forums

mag tube to big boy

mag tube to big boy

Re: mag tube to big boy

Re: mag tube to big boy

Re: mag tube to big boy

Re: mag tube to big boy

Re: mag tube to big boy