Spring has sprung. Get out and shoot your Henry
H009g chronically shooting high
Re: H009g chronically shooting high
I know you have already spent money for the skinner and wish to make it work. But another solution if you dont want to sent the gun back would be a red dot site. They work well. I dont think I would care for the looks of a 1 inch tall front blade on my rifle.
0 x
Don't worry about getting older and still doing stupid stuff. You'll do the stupid stuff as always, only much slower. Hold my beer and watch this.......
H001T .22LR
H001T .22LR MONUMENT VALLEY
H003T PUMP .22LR
BBS .41 MAG
SS .357
SIDE GATE 38-55
H001T .22LR
H001T .22LR MONUMENT VALLEY
H003T PUMP .22LR
BBS .41 MAG
SS .357
SIDE GATE 38-55
- Handloader
- Cowhand
- Posts: 131
- Joined: Thu Dec 28, 2023 5:11 pm
- Location: Maryland
Re: H009g chronically shooting high
I have a Skinner barrel mounted peep with factory front sight on my H010B 45/70 and at 100 yards 4" groups.North Country Gal wrote: ↑Sat Feb 24, 2024 2:20 pmA Skinner barrel mount peep will sit quite a bit lower than any of the Skinner receiver peeps, so you might keep that in mind as a possible solution. I prefer a receiver mounted peep, but have used the barrel mount on a lot of guns and have never had to change out the factory front sight to a taller one. Good chance it would work with that .75"
0 x
Semper Paratus (Always Ready) Semper Gumby (Always Flexible)
Re: H009g chronically shooting high
I went with a Ranger Point Precision peep sight, because I had a base from trying the Cloverleaf sight, which I did not like. Due to the size of the sight and the protective wings on the side of the base, I was not able to adjust windage. Plus, the sight align took some work. So far, I am happy with the results:
You do not have the required permissions to view the files attached to this post.
1 x
Actions speak louder than words (Matthew 7:16-20).
- Cleveraction
- Wrangler
- Posts: 61
- Joined: Sun Jan 03, 2021 11:43 pm
- Location: Hill Country, TX
Re: H009g chronically shooting high
Quick update! Thanks for all the suggestions, I finally got it dialed. Had to remove the Skinner Express (sigh) and keep the large blade front with the factory sights. After some fiddling at 25 took it to 100.... 6/6 in the center orange blob (6 inch diameter) is good enough. I really wanted to use the peep so maybe I will go to the barrel mounted peep sight. What an epic journey.... Hog hunt next week will let you know how we do!
Thanks again.
Thanks again.
2 x
Conservation is a state of harmony between men and land.
~Aldo Leopold
~Aldo Leopold
- Cleveraction
- Wrangler
- Posts: 61
- Joined: Sun Jan 03, 2021 11:43 pm
- Location: Hill Country, TX
Re: H009g chronically shooting high
Oh, a little PSA here. Just got off with the great folks at Skinner. If you ever encounter a similar problem they do make a "short stem" aperture. This can correct for an additional 4.5-ish inches at 100. This means that I will go back to the Express with the short stem, be able to lower it a couple of more turns which should have the same effect as switching to the buckhorn (above). Will let you know how it goes and wanted to pass along the info.
Take care.
Take care.
0 x
Conservation is a state of harmony between men and land.
~Aldo Leopold
~Aldo Leopold