Tube magazine dovetail loose.

[brettitt41]

Got the Henry back today. The paperwork reads as follows.

"Replaced outer magazine tube support." "Cleaned, lubed, and checked over rife. Test fired."

Looks good and I got my scope back onto the pic rail.

Cany anyone comment on if I can expect the scope to be on paper at 100 yards just like when the guy mounted it for me? All I did was dismount from the pic rail, I did not open up the rings themselves. So shouldn't I still be on paper?

Glad you got it back. Your scope should still be close, on paper at least, if the original bore sight was close. Now go shoot it and tell us all about it when you get back.

[markiver54]

If you removed both upper and lower rings, then Personally, I would go ahead and go through the original mounting process.

[JEBar]

if you remount it in the same way, while I doubt it will be dead on, its reasonable to believe it will be close .... looking forward to following your remount and seeing how it goes