Page 2 of 2
Re: 2 Cycle motor
Posted: Thu Apr 23, 2020 11:43 pm
by markiver54
Good luck Jim! Seems these motors are more sensitive than they used to be.
I wanna go fishin...
Re: 2 Cycle motor
Posted: Tue Dec 15, 2020 1:59 pm
by ol'pole
I had the same problem once it turned out to be the water pump impeller located i the lower end
Re: 2 Cycle motor
Posted: Thu Dec 24, 2020 2:46 pm
by clovishound
Running lean will also cause them to run hot. As was mentioned, look at the telltale. That's the stream of water coming out somewhere between the head and the foot. Make sure it is a strong stream, if not then either the pump is failing or there is a blockage somewhere.
As to running too lean, that is likely the carb, which you have hopefully taken care of.