A friendly place to talk about Henry Repeating Arms.....and just about anything else
https://henryrifleforums.com/
Over the years with peep sights, I use them a little different than most. When sighting in I never have the font sight directly where I want to hit. In the case of the bull on the target my sight is at the bottom of the bull. This way I can always see my target and for hunting it provides a better view and depending on distance you can easily adjust higher or lower. It may seem counter intuitive not to have your front sight directly on target, but it is not. Also, it all depends where you have your rear sight located on your gun. I have mine installed where my buck horn sights were located. The further back you locate your peep sights you will notice more movement from your front sight. That is why most buck horn sights are located on the barrel as it is a mid-point which helps in less front sight movement. The further back the sights are located the better the accuracy however you really need to have a steady hand for accuracy to keep your front sight on target.fortyshooter wrote: ↑Wed Jan 24, 2024 8:50 pmDon't know how you do it but that is some great shooting! That 4 inch circle must be smaller than the front sight bead at 100.
100 yards, open sights, big boomer….I’d say that was some excellent shootings. I pity the buffalo that wanders past you.That’s the way to do it, too big of an animal to track down and pack out. Plus a Maine moose is much larger than the little guys around here in the west.Handloader wrote: ↑Thu Jan 25, 2024 10:28 amSome years back in Maine at a bud's land I took down a moose at about 125 yards, one and done dripped right in its tracks.
1100 pounds we used his front-end loader to get to the barn to butcher.Hatchdog wrote: ↑Thu Jan 25, 2024 10:53 amThat’s the way to do it, too big of an animal to track down and pack out. Plus a Maine moose is much larger than the little guys around here in the west.Handloader wrote: ↑Thu Jan 25, 2024 10:28 amSome years back in Maine at a bud's land I took down a moose at about 125 yards, one and done dripped right in its tracks.
A teeth rattler is my .500 S&W magnum lever action loaded with a 400 grain HCGC and 40 grains of H110 coming out over 1800 FPS.
Great info! I have made larger sized peep "ghost ring' inserts with .150 sized hole for all my Henry rifles that go into the buck horn sight.Work great for the older eyes at moderate distances.Handloader wrote: ↑Thu Jan 25, 2024 8:36 amOver the years with peep sights, I use them a little different than most. When sighting in I never have the font sight directly where I want to hit. In the case of the bull on the target my sight is at the bottom of the bull. This way I can always see my target and for hunting it provides a better view and depending on distance you can easily adjust higher or lower. It may seem counter intuitive not to have your front sight directly on target, but it is not. Also, it all depends where you have your rear sight located on your gun. I have mine installed where my buck horn sights were located. The further back you locate your peep sights you will notice more movement from your front sight. That is why most buck horn sights are located on the barrel as it is a mid-point which helps in less front sight movement. The further back the sights are located the better the accuracy however you really need to have a steady hand for accuracy to keep your front sight on target.fortyshooter wrote: ↑Wed Jan 24, 2024 8:50 pmDon't know how you do it but that is some great shooting! That 4 inch circle must be smaller than the front sight bead at 100.