Some BP questions

Post by **RanchRoper** » Sun May 02, 2021 6:14 pm

If I was to get one it would likely be the same one.

Post by **BigAl52** » Wed May 12, 2021 10:15 pm

Got the .490 and.495 balls I ordered from October Country. I must say they are really well done. I will be ordering more from them when I need more. They a sprueless which is really nice.

Post by **RanchRoper** » Wed May 12, 2021 11:04 pm

Caps are still scarce here. I have several thousand but keeping watch for more.

Post by **RanchRoper** » Fri May 14, 2021 9:47 pm

Might be able to get my hands on some RWS1075 caps.....stay tuned.

Post by **BigAl52** » Fri May 14, 2021 10:38 pm

Those a good caps but they are usually more money

Post by **RanchRoper** » Fri May 14, 2021 10:54 pm

If all goes well tomorrow morning I will have 14 tins coming.

Post by **armycat** » Sat May 15, 2021 1:17 am

How critical is lead quality and the ratio of lead to tin? I had a pile of damaged ammunition, .22 misfires, etc and melted down the bullets and saved the lead. I tried molding some .50 cal balls but they had some ripples in them. I attributed this to not preheating the mood. Could it be that the lead mix I am using is no good. I haven’t actually shot blackpowder yet. Have to build my rifle first.

Post by **RanchRoper** » Sat May 15, 2021 9:19 am

I don’t cast my own yet so not sure.

Post by **RanchRoper** » Sat May 15, 2021 9:28 am

Yeehaw! 1400 caps on their way.

Post by **BigAl52** » Sun May 16, 2021 12:03 pm

Where did you find those in the States

Henry Rifle Forums

Some BP questions

Re: Some BP questions

Re: Some BP questions

Re: Some BP questions

Re: Some BP questions

Re: Some BP questions

Re: Some BP questions

Re: Some BP questions

Re: Some BP questions

Re: Some BP questions

Re: Some BP questions