Forty's peepsight.

[Vaquero]

Well I finally replaced the benchgrinder, and made one of Forty's peep sights for the 44 mag BBB.
With a slight elevation adjustment I was wearing the 10" gong out from the deck.
Lol, it's still red as a redneck, I will remove a little more off the top and give it a shot of black paint.

20210714_174856.jpg (226.46 KiB) Viewed 1648 times

20210714_174748.jpg (205.47 KiB) Viewed 1648 times

RP

[BigAl52]

Looks Good Randy. I sure like mine comes highly recommended

[Rifletom]

Looks just fine Randy. You and forty are getting it done! Likin' those.

[Sir Henry]

I like it.

[richg87]

I like it too! I need to make one.

[fortyshooter]

Randy... get a bit of Acetone and the paint will come right off revealing a nice blued finish! Good job and glad it works well for you.

[RanchRoper]

Cool.

[Vaquero]

Well after shootin the one on the Marlin, I went back to the drawing board.
Pulled out a drill bit and went with a tad smaller hole.
Will try it later.

RP

[fortyshooter]

What size hole? The hacksaw blades usually have a .156 or 5/32 hole.

[Vaquero]

The drill bit measures .122.
Might not make much difference, but heck it only takes a couple mins. to whittle one out.

RP