Henry Rifle Forums

I finished the 3/16" combo setup to the point where I could use it today. I still have to attach some legs to make it portable but the brackets won't be here until late next week and I didn't want to wait any longer. I set them up at 75'. The little 3" one isn't getting much paint knocked off yet, as I'm only whacking it about every 3rd shot.

I also got a 10" (1/4") gong for the Henry 357's and 4" and 6" gongs out of 3/8" for the AR15's. I'm still contemplating how I'm going to mount them but the .22's see a lot more use so they were priority.

nicely done .... enjoying watching you progress

Glad you like those they are a great company to do business with I think.

Very nice setup. Should provide many hours of fun shooting. Congrats.

Can't have to much steel to plink on! Great setup and challenge with the smaller targets. Still looking for my missing 3 inch that took a hard .357 hit with a 180 gr. Henry fired pug. It and chain gone!

I just put a second chain on that small 3" target as a good solid hit caused it to wrap around the 2x4. I can see how a 357 Mag would send it to the woods.
This sure beats all the walking back and forth every 3 shots to see how you're doing. I like them.

Nice! I’ve found they are as much fun to design and build as they are to shoot.

Nice set up. Watching the steel jump is a whole lot more fun than putting holes in paper.

Paul