Page 3 of 4

Re: Anyone else have this issue...

Posted: Sun Feb 16, 2020 3:21 pm
by CT_Shooter
BB, the Henry H001 is also known as the Henry Classic.
Bad Bob wrote:
Sun Feb 16, 2020 3:19 pm
Maybe I missed it, but what model, exactly is a "Classic" model??

Re: Anyone else have this issue...

Posted: Sun Feb 16, 2020 4:38 pm
by BigAl52
Bad Bob wrote:
Sun Feb 16, 2020 3:19 pm
Maybe I missed it, but what model, exactly is a "Classic" model??
Good advice to E-Mail the owner, you WILL get some help and answers..
https://www.henryusa.com/rifles/lever-action-22-rifle/

Here is the link Bob

Re: Anyone else have this issue...

Posted: Tue Feb 18, 2020 9:05 am
by fortyshooter
Just following this but could the magazine tube spring be weak not having the needed pressure to completely feed the last round?
I know on a 1911 pistol the last round feed issue is usually a weak mag spring. Just thinking here.

Re: Anyone else have this issue...

Posted: Sat Feb 22, 2020 10:00 pm
by sawdusty
Hi guys. My 1st thought would be you don't have enough tension in your spring to push the last round where it needs to go. I 'd start w/a new tube, whether Anthony will give you one or you pick 1 up on line. Jerry

Re: Anyone else have this issue...

Posted: Sun Mar 01, 2020 7:31 am
by shoota40
Just call customer service and request a new magazine tube and tell the representative why and you will be sent a new magazine tube. I called asking for a new o-ring for my magazine tube and was sent a new magazine tube at no charge. The folks at Henry are more than happy to please their customers.

Re: Anyone else have this issue...

Posted: Sun Mar 29, 2020 10:55 pm
by ozark75
I had the exact same problem with a Big Boy Brass in 357. They eventually sent me a new gun. I tested 10 rounds, everything was ok. Finally took it out to the range after 5 months, problem showed back up. I believe the mag rod spring got weak while sitting loaded (not chambered) for 5 months. I have a current thread in the centerfire subforum asking about aftermarket springs. Doesnt seem factory spring likes to be left with a full mag tube (which will pose a problem for me as this is my home defense gun).

Re: Anyone else have this issue...

Posted: Mon Mar 30, 2020 8:42 am
by Mistered
up. I believe the mag rod spring got weak while sitting loaded
A spring should not weaken by just being left compressed - even long term.
Continual compression and relaxation is what weakens them and even then load tube springs are not subjected to enough of this to affect them much.

Re: Anyone else have this issue...

Posted: Mon May 25, 2020 6:39 pm
by Dirko
My new Golden Boy does this. The inner tube of the magazine has an orange follower. On my the follower is stuck inside the tube. They are sending me a new tube. Hopefully that will fix it so I don't have to count shots.

Re: Anyone else have this issue...

Posted: Tue Jun 09, 2020 5:48 pm
by Dirko
After receiving my new tube, my Henry has preformed flawlessly.

Re: Anyone else have this issue...

Posted: Tue Jun 09, 2020 5:58 pm
by BigAl52
Good to hear glad its fixed.