Spring has sprung. Get out and shoot your Henry
solid hard cast
solid hard cast
I just purchased a Henry side gate 45-70. the only ammo I was able to find, was Doubletap 405 gr Hard cast. Is this ammo o.k. to shoot in the brass rifles?
0 x
-
- Cowhand
- Posts: 321
- Joined: Thu Jun 09, 2016 11:37 am
- Location: Texas
Re: solid hard cast
Yes, the Underwood ammo is good stuff. It is punchy on both ends. The cowboy stuff is a lot tamer. Think about reloading seriously unless of course your sitting on Ft. Knox. You can run the full gambit of very well behaved Trapdoor loads to near .458 magnum. I hope you will like your new Henry.
Muddy Waters 67
Muddy Waters 67
1 x
Re: solid hard cast
I can feel that one before you pull the trigger. It will say hello to you for sure.
1 x
Don't worry about getting older and still doing stupid stuff. You'll do the stupid stuff as always, only much slower. Hold my beer and watch this.......
H001T .22LR
H001T .22LR MONUMENT VALLEY
H003T PUMP .22LR
BBS .41 MAG
SS .357
SIDE GATE 38-55
H001T .22LR
H001T .22LR MONUMENT VALLEY
H003T PUMP .22LR
BBS .41 MAG
SS .357
SIDE GATE 38-55
- JEBar
- Town Marshal / Deputy Admin
- Posts: 19339
- Joined: Sun Mar 20, 2016 10:58 pm
- Location: central NC
Re: solid hard cast
I agree with MuddyWaters .... when you pull the trigger, be prepared for a punch
0 x
Re: solid hard cast
It'll get your attention for sure. The Henry action is over built like a tank so any factory load is fine. If reloading just follow established data
0 x
30-30, Helping bad fisherman eat since 1895