Lever Stuck Open H009 30 30

[PJM]

On my H009CC 30-30, the bolt slides out readily without removing anything more than the lever! As someone else noted, you have to fully depress the hammer.

[GFK]

On my H009CC 30-30, the bolt slides out readily without removing anything more than the lever! As someone else noted, you have to fully depress the hammer.

Yep, I must have missed this the first time around, when I read the owner's manual:

HOW TO CLEAN YOUR HENRY .30/30 RIFLE You do not have to disassemble this rifle in order to clean it sufficiently and to keep it operating properly. In order to clean it, we suggest that you first open the action by swinging the lever down. Use a brand name rifle cleaning kit and run the cleaning rod down the bore from the muzzle end toward the breech. Wipe the bolt clean of any debris with solvent and a patch or small rag. Spray the bolt with some gun oil. If you prefer to take your rifle apart to clean it, then we suggest the following: Open the action by swinging the lever down. Remove the lever screw and then remove the lever. Next, remove the bolt from the receiver. Note: This will loosen the ejector inside the receiver, so be very careful not to misplace it. You can then remove the ejector from the slot on the left side of the receiver. Use a brand name rifle cleaning kit and clean the bore from the breech end. Then clean the bolt and oil it before replacing. To reassemble, simply do the reverse. (page 9)

[hunter51]

I have a HO24 in .35 Rem. My problem is that my rifle will not feed. It jams and locks up the lever. If I manually feed a round in the chamber ,the trigger will not release. This is the second time I sent it back to Henry. I hope that they resolve this problem.

[BigAl52]

Was it the same issue both times?

[JEBar]

I have a HO24 in .35 Rem. My problem is that my rifle will not feed. It jams and locks up the lever. If I manually feed a round in the chamber ,the trigger will not release. This is the second time I sent it back to Henry. I hope that they resolve this problem.

good to have you join our forum, sorry to hear about the issue .... looking forward to your report about the repair .... be sure to follow the link below where you may add yours to our community's total

http://henryrifleforums.com/viewtopic.p ... 08#p141108