Spring has sprung. Get out and shoot your Henry
Foley-Belsaw/ Craftsman planer
Foley-Belsaw/ Craftsman planer
Found new feed rollers for this 12" 5 hp planer so I am going to replace the old ones which are too slick to pull planks through. Found a manual on the Belsaw website but cannot locate new drive chains on any site so I am going to clean up the old ones and lube them before re-installing. No idea how old these are but when they break I think I am hosed. Taken off the covers and gotten pictures of everything in place and spraying all the bolts with Blaster hoping this will go smoothly. Intending to get into it this week after work, just have to get brave enough to start tearing things apart.
0 x
Re: Foley-Belsaw/ Craftsman planer
Ernie, I hope your project goes well. A good tool is well worth maintaining. Good luck.
1 x
Remember, it's not how many guns you have. It's how many bullets you have.
Re: Foley-Belsaw/ Craftsman planer
Found some more parts but they are pretty expensive. Will only buy if needed but it is nice to know they are still available.
0 x
Re: Foley-Belsaw/ Craftsman planer
Replaced the feeder rollers in the planer yesterday. Was a bit of a challenge removing the drives and returning everything properly. Fortunately I had located a manual with an exploded parts diagram and took plenty of before pictures. Cleaned chains in kerosene and used chain lube. Had to manually work each link to free up and get lube worked in, and greased up all the bearings. Works great. Now have a functional old workhorse, they don't make them like this anymore.
before removal
finished project after trials.
1 x
Re: Foley-Belsaw/ Craftsman planer
This is very interesting to me and thanks for posting. I have a Belsaw 902 planer. It makes yours look like it was made last week. The good news is that the feed rollers have one vee belt and the rest of the drive is gears. The cutter head only has two blades but by replacing the driven vee pulley I was able to slow down the feed rate so that even rough grain comes through smooth. The motor is an old GE. repulsion induction three hp. that looks like the Mayflower pilgrims bought it used. It runs great and can handle a twelve inch walnut or ash board without strain.
1 x
Re: Foley-Belsaw/ Craftsman planer
Is the cutter head designed for 2 blades or is that just what you have left? I got this planner 20 years ago and used it on two projects then parked it until I got new blades and feed rollers and actually got them installed. This has a 5 hp motor and it is a beast. Got a kick out of looking at the manual for the saw, sander, and shaper accessories.
0 x
Re: Foley-Belsaw/ Craftsman planer
The cutterhead is made to hold only two blades. They are bolted on and are about five sixteenths thick. The G.E. motor has oil cups with spring loaded lids and a little wick inside the curved tube that leads to the bearings plus a little swing away curved lid that covers the set screw that is in the middle of the end bearing on each end of the motor. If I haven't used the machine for a few weeks or longer , I remove the set screw and put a drop or two of oil right on the shaft.
1 x